How do I make nightcrawler shocking rods? - electrical torture videos
My grandmother take these points into wooden handles, along a power line. These things catch up ROCKED worms. We have to sell. Fun stuff.
Now I have two children, down 10 to 12 years who love fishing and would love the worm.
Now I felt like I was pretty sure my hunting time to them. I remember a bit of jogging once or twice, but not fatal.
I want a safe method, with detailed instructions on how to make these devices to torture. Hahaha!
Sunday, January 31, 2010
Electrical Torture Videos How Do I Make Nightcrawler Shocking Rods?
2 comments:
It takes two screwdrivers or metal rods, or when a power switch for at least cause.
The idea is to increase the electric current on the ground, rising crawler.
Screwdriver could be, but the metal bars better --- take an extension cord and cut end.Strip woman of about 2 meters from the outer insulation, have 3 son left.Cut the green wire. Strip to leave a black and white insulation around 6 inches both.Find 2 metal rods (rods bar working again especially about 2 meter cable) long.Wrap bare wire on each metal rod, d "about 4 cm high and wrap duct tape equipment.
In the package with a ribbon at the top, or some other heavy wood buttons (the son of current isolated)
The saturated water until the grass and then sticking the stems into the ground as far as the son of the insertion of the cord and wait permit.NOW ----- power goes from bar to bar, completing the circuit (wet soil is a must, therefore, water) and worms appear wear.UNPLUG nothing worse for cable and select another area --- Repeat if necessaryY. .........
Close the insert extension agreement in an exterior wall and then connect to a long screwdriver with tape elextrical Dont forget to some plastic covoring for electric cables, then remove the tape on the metal surface of the driver, and press the handle into the ground or U can do Sam, but with the jumper cables in your car, if n U to
PS: I just last week after the rain, worked perfectly
Post a Comment